FBs Etherner communication Expansion Card (Front Mount)
 
Specifications
 
NP jumper: When the left two pin headers are short circuit, refers to no
password protection. (If the firmware version is less than V7.6, the NP mode is
not to connect the jumper)
Boot jumper: When the right two pin headers are short circuit, forced to enter
Boot mode after booting.
 Ethernet status indicators (Link): When light means the network connection is normal, flash means there has data activity on the network.
Ethernet status indicators (Speed): Lights on means the connection speed is
100Base-TX, off means 10Base-T.
Port1 RX green signal indicator of the CPU module: Lights on means CPU
module port1 has sent messages to the board.
Port1 TX red signal indicator of the CPU module: Lights on means the board has
sent messages to the CPU module port1.
 Port1 RX green signal indicator of the CPU module: Lights on means CPU
module port2 has sent messages to the board.
Port2 TX red signal indicator of the CPU module: Lights on means the board has
sent messages to the CPU module port2.
Ethernet connector: RJ45 standard connector.